44
Failure
Possible cause
Solution
Wrong writing method
Use the pen rather than a finger to write.
Grasp the pen as far to the nib as possible.
The angle between the pen and display
should be larger than 60 degrees. Do not let
sleeve or wrist touch the writing surface.
Not sound and image
1.
Check if the power cable is connected to the power socket and if the panel
is connected to power.
2.
Check if the rocker switch on the interactive panel is switched on.
3.
Check if the
Standby
button on the panel is pressed.
4.
Check if the video and audio input cables are connected correctly.
5.
Check if the panel is switched to the right signal source.
6.
Check settings including image luminance and contrast.
7.
Check the volume.
Image is normal, but no
sound
1.
Check the volume.
2.
Check if the
Mute
button on the remote controller is pressed.
3.
Check if the audio cable between the PC and interactive panel is connected
correctly.
No image or the image is
black and white
1.
Adjust color settings.
2.
Check the color system.
Image or sound is
interrupted
1.
Find out the electric appliance that causes the interference and move it
away from the interactive panel.
2.
Do not connect the panel to a power socket that a disrupting electric
appliance is connected to.
The remote controller fails.
1.
Change the batteries.
2.
Clean the launch window at the top of the remote controller. (Check if it is
blocked)
3.
Check contacts of the batteries.
Computer cannot be started
(applicable for models with
computers)
1.
Check if the computer adapter is correctly connected and is connected to
power.
2.
Check if the computer is connected correctly to the interactive panel.
Self-inspection:
The following phenomena are not failures:
Given the high-precision production technology, the LED panel may have a very few constantly bright or
dark pixels, which turn out to be tiny red, blue, green or dark points on the panel. The phenomenon is
normal.
The panel may make slight sound when it is adjusting backlight or it is cooling.
When the image and sound are normal, and you touch the LED panel with fingers, you may feel static
electricity. The temperature of the rear of the panel and product is high. These are normal phenomena.
Instructions in
Provisions for Recycling and Disposal of Waste
Electrical and Electronic Products
The
Provisions for Recycling and Disposal of Waste Electrical and Electronic Products
(Order
No.551) was issued by the State Council on August 20, 2008, and became effective on January 1,
2011.
When you no longer need to use the product, you must comply with laws and regulations on recycling
and disposal of waste electric and electronic products to return the waste product to a company licensed
for receiving and disposing waste electric and electronic products.
You can also send the waste interactive panel to HiteVision’s service centers across the country.
Содержание 70GT deluxe series
Страница 19: ...19 Clock Calendar Calculator...
