Controlador por cable YAP1F6
Operation guide
1.
After putting through the power, press "ON/OFF" button on remote controller to turn on the air
conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3.
Press "▲" or " " button to set your required temperature. (Temperature can’t be adjusted
under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low speed, low-medium speed,
medium speed, medium-high speed, high speed.
5.
Press "
" button to select fan blowing angle.
Replacement of batteries of the remote controller
1.Lift the cover along the direction of arrow (as shown in fig. 1
).
2.
(as shown in fig. 1 ).
3. Place two new AAA 1.5 V batteries and make sure that the
“+”and “-” pole
positions are correct (as shown in fig. 2 ).
4. Reinstall the cover (as shown in fig. 2 ).
Fig. 1
Fig. 2
NOTICE
● During operation, point the remote control signal sender at the receiving window on
indoor unit.
● The distance between signal sender and receiving window should be no more than
8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp or wireless
telephone; remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don’t use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there’s no display, please replace
batteries.
USM_CONTROL FLEXIA-K_208518_210401_ES
▲
