HITEC Flash 8, Инструкция по эксплуатации

Страница: 8 / 59

12 13
Powering the FLASH 8
FLASH 8 is composed with Li-Fe 2Cell battery.
FLASH 8 is operated under DC 4.8~ 8.4V. It is also capable to use 2 cell Li-Fe or 4 cell NoMH or Li-Po/Li-ION
battery.
Selecting the Battery Type
The standard battery type of FLASH 8 is a Li-Fe 6.0V that has setting for low voltage alarm system.
If you choose to use a different type of battery you must select the battery type in the System
Management menu.
The preset warning thresholds for each type are
LiFe 6.0 Volts
NiMh or NiCd 4.3 Volts
LiPo 7.0 Volts
Alkaline 4.0 Volts
How to connect and charge battery of Flash- 8
Battery connection
1. Press along with the ‘arrow’ mark on the back of the radio to open the battery compartment or close
the cover until you hear the click sound.
2. Please check the provided image when connecting the battery to the connector.
3. Close the cover to the battery compartment.
Battery charge
Please be sure to fully charge the batter when it is the first time to use or also when you have not used it
for a long time
1. Please turn off the power of the radio after connecting the supplied battery to the radio..
2. As shown on diagram (Next Page), please connect the adapter to the charging port on the side of the
radio.
Red LED light shows that the battery is currently charging.
Make sure you use a charger suitable for the battery pack you are using. It is recommended that
you remove the battery from the transmitter when charging it.
Warning
Be careful when opening the battery cover to prevent any possible injury.
Warning
Any excessive force may cause damage to the battery cover. .
Caution
Please be sure to use only the provided Adapter provided in the gift box. Using other non
certified charger may lead to damage of the battery(i.e explosion) or may even cause serious
damage to the radio.
Caution
Please be sure to use the supplied Hitec battery with the supplied Hitec adapter to prevent any
possible damage for any battery explosion.
Caution
3. The light will be eliminated after 6 to 8hours, when the battery is fully charged.
The standard battery type of FLASH 8 is a Li-Fe 6.0V that has setting for low voltage alarm system.
We do not take any responsibility for any damage of the product due to wrong use of other
adapters rather than the Hitec RCD’s supplied adapter.
Warning
Supplied Li-Fe from Hitec has a built-in protection circuit that may lead to damage of the battery
in case of quick charge or quick discharge. Supplied battery must use only Hitec adapter. In
addition, Hitec RCD does not cover the service charge on any damages that has been occurred
with using any other charging adapters.
Warning
Power Meter
On the home screen of the FLASH 8 you can visually see the voltage reading as well as a bar indicating
the amount of power left in the battery.