HITEC Flash 8, Инструкция по эксплуатации

Страница: 46 / 59

88 89
6. Scroll to highlight “S/W” and press the jog dial to activate the
switch menu.
7. Scroll to select a switch to activate throttle cut. Press the jog
dial to confirm your selection.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight the
switch position that you will use to enable throttle cut. Press
the jog dial to confirm your selection.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the
top right corner of the screen will indicate when the mix is
active.
The momentary “deadman” switch (Switch-H) is a convenient and commonly-used throttle cut
switch. Throttle cut should be off when the switch is in its neutral position.
a. If you choose the “NULL” option, throttle cut will remain
inactive at all times for this model.
Thro Cut (Acro Only) cont.
8. Press the back button to return to the model function menu.
To disable throttle cut:
1. Scroll to highlight the “MIX” field in the throttle cut menu and
press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the Back button to return to the model function menu.
Tip Tip
Tip
1. From the model menu, rotate the jog dial to highlight
“T.Curve” and press the jog dial once to enter the activation
menu.
T. Curve (Acro Only)
The Throttle Curve function allows you to modify the normally-linear servo rate movement for throttle by
defining five different points along the throttle response curve.
To configure a throttle curve:
T. Curve (Acro Only)
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to confirm your selection and activate the throttle curve
menu.
4. Scroll to the “1” field and press the jog button to activate the
menu.
5. Rotate the jog dial to input the desired throttle position at this
point on the curve (Throttle stick full down).
6. Scroll to highlight the “2” field and press the jog dial to
activate.
7. Rotate the jog dial to set the desired value of “Y” axis on the
left when right roll command is given. Press the jog dial to
confirm your input.
8. Rotate the jog dial to set the desired value of “X” axis on the
right when right roll command is given. Press the jog dial to
confirm your input.
9. Point according to throttle stick can be set the desired value
using steps 4-8
10. Scroll to the “EXP” (exponential) field and press the jog
button to activate the menu.
11. Rotate the jog dial to select “OFF” or “ON”. When “ON” is
selected, the points in the curve are connected with
exponential curves. Otherwise, the points are joined linearly.
Press the jog dial to confirm your selection.
12. Rotate the jog dial to highlight “OST” and press the jog dial
once to enter the menu.
13. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired value of offset in the Throttle
when right roll command is given. Press the jog dial to
confirm your input.