detail.
<Back>
Q. When I set the end point on my servo, it will only affect one direction.
A.
End points allow you to set both ends of stick travel to different percentages. To do this, hold
the stick in one extreme and set the percentage that corresponds. Then move the stick in the
opposite direction and set that percentage.
For example, if you wish to set the end point on your aileron, go to the EPA menu and make sure
that channel 1 is blinking. If it is not blinking, use the rudder (ch 4) trim lever to scroll through the
channels until you reach channel 1. Then hold the aileron stick to the right. While holding it in this
position, adjust the percentage value on the screen with the aileron (ch 1) trim lever. Then move
and hold the stick in the left position and change the percentage value for that direction.
<Back>
Q. Why do the centers on my servo move when I switch from high to low dual rate?
A.
The radio may require recalibration. Return the transmitter to Hitec service for evaluation.
<Back>
Q. What other receivers will my Flash work with?
A.
The Flash radios are compatible with negative shift FM (PPM) receivers only.
<Back>
Q. What is the maximum range of the Flash transmitter?
A.
Approximately 2 miles, but we refer to it as "line of site." If you can see it, you can fly it!
<Back>
Q. How do I do a range check?
A.
With your transmitters antenna collapsed, walk away from your receiver until the servos start to
jitter. You should get a minimum of 75ft. If you get significantly less we recommend that you do not
fly until you isolate the problem.
<Back>
Q. When I use elevon mixing, how do I adjust the throw of the elevator only?
A.
You can use the D/R menu to adjust the total throw of the elevator.
<Back>
Q. Does Hitec make the Flash System X radios in the Ham Band?
A.
Hitec does not offer radios in the ham band.
<Back>
Q. Will this do full house sailplanes?
A.
A "full house" sailplane requires the use of at least 6 channels.
<Back>
Q. When I enable aileron/rudder mix, the rudder only moves in one direction when the
aileron stick is moved?
A.
Both directions of the rudder have to be set. To do this, enter into the ail-rud menu. Hold the
aileron stick to the right and change the percentage showing with the aileron trim. Then move the
aileron to the left and set the new percentage.
<Back>
Hitec RCD : Pages
file:///C:/DOCUME~1/Alan/LOCALS~1/Temp/maftemp-e87516b0/1358...
2 of 3
24/01/2013 10:55 a.m.
