HITEC Aurora 9X, Инструкция по эксплуатации

Страница: 22 / 144

9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM
Hitec 2.4GHz System
FAIL-SAFE and Hold Mode Setup
If you use and set up the FAIL SAFE function properly and the receiver signal is somehow interrupted, the servos will move to your
previously stored FAIL-SAFE setup.
If you do not activate the FAIL-SAFE function, the signal is switched off after the HOLD period of 1 sec. This means that the servos become
“soft” and remain in their last commanded position under no load (this may equate to full-throttle!), until a valid signal is picked up again.
In the interests of safety, we recommend that FAIL-SAFE should always be activated, and the FAIL-SAFE settings should be selected so as to
bring the model to a non-critical situation. (e.g. motor idle / electric motor OFF, control surfaces neutral, airbrakes extended, aero-tow
release open, etc.)
Fail-Safe position
Press and hold the button on the receiver until the LED turns off
(approx. 6 seconds).
Release the button. After 2 seconds both red and blue LEDs blink alternately.
The receiver will count 5 seconds. During that time, move all the transmitter
sticks and other controls to the desired FAIL-SAFE positions (e.g. motor idle,
control surfaces neutral), and hold until the blinking stops.
When the blinking stops, the system will temporarily
remember the FAIL-SAFE position. Turn off
the system to save and exit.
www.hitecrcd.com
2Sec.
6Sec.
Switch on both.
Wait for the system to boot and you have
control over the model.
22