English
37
HOW TO USE
1. Check the rotational direction
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the pushing button.
The L-side of the pushing button is pushed to turn
the bit counterclockwise (See
Fig. 7
) (The and
marks are provided on the body).
CAUTION
The pushing button cannot be switched while the impact driver is turning. To
switch the pushing button, stop the impact driver, then set the pushing button.
2. Switch
operation
○
When the trigger switch is depressed, the tool rotates. When the trigger is released, the tool
stops.
○
The rotational speed can be controlled by varying the amount that the trigger switch is
pulled. Speed is low when the trigger switch is pulled slightly and increases as the trigger
switch is pulled more.
○
When releasing the trigger of the switch, the brake will be applied for immediate stopping.
NOTE
A buzzing noise is produced when the motor is about to rotate. This is only a noise, not a
machine failure.
3. Using the hook
The hook is used to hang up the power tool to your waist belt while working.
CAUTION
○
When using the hook, hang up the power tool
fi
rmly not to drop accidentally.
If the power tool is dropped, it may lead to an accident.
○
When carrying the power tool with hooked to your waist belt, do not
fi
t any bit to
the tip of power tool. If the sharp bit such as drill is
fi
tted to the power tool when
carrying it with hooked to your waist belt, you will be injured.
○
Install securely the hook. Unless the hook is securely installed, it may cause an
injury while using.
(1) Removing the hook.
Remove the screws
fi
xing the hook with Philips screw
driver. (
Fig. 8
)
mark
mark
Trigger switch
Pushing button
Fig. 7
Screw
Groove
Hook
Fig. 8
000Book̲WH14DBDL2̲ChS.indb 37
000Book̲WH14DBDL2̲ChS.indb 37
2017/12/07 18:05:01
2017/12/07 18:05:01
