Important information for customers
in Great Britain
This set is fitted with an approved moulded 13 amp plug. To
change the fuse in this plug or to attach a different plug,
please proceed as follows:
1
Take off the fuse cover and remove the old fuse.
2
Insert a new fuse. Suitable fuses are those of the type BS
1362 3A, A.S.T.A. standard or BSI standard.
3
Close the fuse cover.
If the attached plug does not meet your requirements, you can
cut it off and replace it with a suitable plug. Please observe the
following conditions:
•
If your new plug uses a built-in fuse, this should be a 3A
fuse.
•
If your new plug does not contain a built-in fuse, please do
not use any fuses in your fusebox with a rating of more
than 5A.
•
Please destroy the old, cut-off plug so that it cannot be
used elsewhere.
1
Connect the blue cable (neutral 'N') to the terminal in the
plug which is marked with the letter 'N' or coloured black.
2
Connect the brown cable (live, 'L') to the terminal in the
plug which is marked with the letter 'L' or coloured red.
3
Do not in any circumstances connect either of the two
cables to the terminal in the plug which is marked with the
letter 'E', the symbol "\" or coloured green or green /
yellow.
Before you refit the plug cover, make sure, that the grip at
the bottom of the plug is clamped over the plastic cover of
the lead, not just over the two wires.
3
