Hitachi VT-M190A, Руководство пользователя

Страница: 25 / 91

CHANNEL MEMORY PROGRAMMING (Without a Cable Box)
25
CHANNEL MEMORY PROGRAMMING (Without a Cable Box)
Channel memory programming is NOT needed when connected to a CABLE BOX. You
can program the tuner to scan only the channels you receive in your area. See page 31
for channel designations.
You must use remote control for this procedure.
NOTES:
Follow the steps below, once. Repeat it only if there is a power failure or the VCR is
unplugged for more than 30 seconds. In these cases, since the programmed channels are
erased, the VCR will prompt you with "--:--" when you turn it on.
You must follow the steps below before attempting to play or record a video tape. If you
want to play ore record a video tap BEFORE programming the tuner, you must first press
POWER button to turn off the VCR. Then, press POWER button again to turn it back on.
To program the tuner again, see "To preset channel memory again" on this page.
1
Plug the VCR power cord into a standard AC outlet. The "--:--" flashes.
2
Press POWER button to turn on the VCR to that the " " appears on the display.
3
Turn on the TV and set the TV channel to the same video output channel located on the
back of the VCR. (CH3 or 4)
4