Hitachi VT-F462A, Инструкция по эксплуатации, Страница: 46 / 84

PLAYBACK
46
SET GO-TO TIME
TIME 0:32
PRESS
F . FWD OR REWIND
TO START
PRESS CLEAR TO CORRECT
*TO END PRESS INDEX
3. Press the REW button to search the scene 32 minutes before the present position or the F.FWD button
to search the scene 32 minutes after it. The tape is rewound or fast forwarded to the position 32 minutes
before or after, and then playback starts.
Tape indexing
The indexing system used in your VCR is based on a new VHS Standard Indexing System called "VISS"
(VHS Index Search System). It allows you to directly access specific program segments. The new system
used in your VCR will not recognize index marks on tapes made on older VCR's. Likewise, older VCR's
cannot recognize the "VISS" index marks. The INDEX "mark" is recorded automatically every time the
REC button is pressed.
Note: Normally, an index "mark" is not recorded if PAUSE is pressed and released during recording. You
must press the REC button. If you are recording two programs - one immediately following the other - you
must press STOP and then REC to insert an index "mark".
1. Press the GO-TO/INDEX button once during the stop mode.
The index menu appears on the TV screen.
SET GO-TO TIME
TIME -:--
INDEX
PRESS F . FWD OR REWIND
TO START
SCAN AND PLAY
*TO END PRESS INDEX
2. Press the REW of F.FWD button. The tape will rewind or fast forward until an index signal is detected.
3. When the VCR locates an index mark, it will stop and play approximately 15 seconds of the program
following the mark. This is long enough for you to recognize the program.
4. The VCR will continue to locate index marks in either direction and play 15 seconds of the program
following it until you press GO-TO/INDEX.
5. When you see the program you want to watch, press PLAY.