Number
Description
■
LAN card 1
■
Hard drive
■
System standby power
2
Reset button.
3
Power button. Applies power to or
removes power from the SVP.
SVP rear panel
The only ports used on the rear panel of the physical SVP are the power socket and the
four LAN ports.
Number
Description
1
Power socket. Attach the power cable
supplied with the SVP.
2
Four LAN ports arranged as follows:
LAN3 LAN4
LAN1 LAN2
These ports connect to your IP network,
the management console PC, and the user
LAN port on each storage system
controller.
Note: After the Initial Startup Wizard is run, the SVP can be used in non-
bridge mode. In this mode, the cables can be removed from SVP ports LAN3
and LAN4 and attached to switches. For more information, contact customer
support.
SVP rear panel
Chapter 6: Service processor
Hitachi Virtual Storage Platform G800 Hardware Reference Guide
60