31
JET-1050 PCI TEST Card
JET-1050 PCI TEST Card specification
Include all JET-1048 function.
Real time and without probing to show 10 PCI signals
--- Real time monitor
the 10 PCI Bus signals (such as CLK, RESET#, FRAME#, TRDY#, DRDY#,
DEVSEL# and C/BE[3:0] signals) by indicator LEDs. The each indicator LED
showed as following status for each respective signal.
o
Indicator LED
on (light)
to indicate its respective signal in
low voltage
state.
o
Indicator LED
off (dark)
to indicate its respective signal in
high voltage
state.
POST code reset function
--- JET-1050 will output a pulse signal when the
current POST code output value equal to the DIP switch setup of card. (User can
setup the POST code event from 00 to FF). This function is useful to apply for
o
System reliability testing --- The system will only restart when a specific
POST code output (setup by DIP switch) . In another word, the system
will stop when it doesn't reach the specific POST function. For example,
the A BIOS process the POST routine from 01(Power on 1st routine), 03
06, ... 4E, .. 00(boot-strap) before booting the Operating System. User can
setup DIP switch to "00" for this mode, and check the POST code
indicator of JET-1050 for
POST code keep running from power on to boot --- User can find
the POST code indicator output different value on it. And it will
re-start the system when POST code output = "00".
POST code stop a fixed value -- It indicates the system can not
pass this POST function during the reliability testing.
Fixed time reset function
--- JET-1050 will output a pulse signal upon CN1
after system power on about N seconds. ( N value is setup by DIP switch from 1
to 255). This function is useful to apply for
