Hitachi RAM-200FPS, Инструкция по установке и обслуживанию

Страница: 8 / 24

8
4.3 Foundation Work
1) Anchor bolts installation, lock method and fixed examples.
2) To avoid dumping the body resulting noise, or due to gusts and earthquakes caused by inclination. So be sure to make
the outdoor units foundation work is really.
3) Confirm the drainage smooth flow
When Defrost operation, the condensation water will be
discharged, select the best drainage of areas, the water
discharge to drainage ditch. The drain hole position shown
at right:
4) Setting shelf use standard parts, when the standard parts width narrower than outdoor unit base bracket, please follow
the figure below
：
between the standard parts shelf and outdoor unit base bracket feet, into the wider flat to withstand
full weight of the outdoor unit.
(560)
Hole
4-
Φ
16 x 23.5 Long Hole
If ensure
※
170 dimension, and without
interference with foundation base, it can be
downward the piping work.
To avoid the unit vibration
transmitted to the buildings, if
necessary to install anti-vibration
rubber.
Fixed Bracket (Fielded supplied)
2
1
m
m
B
e
low
(
A
A
ft
e
r Cu
t O
ff
)
Concrete
Anchor Bolt
Shelf Width 60 mm
(Standard Parts)
Outdoor
unit base
bracket can
not fully
load the unit
weight.
Outdoor unit
base
bracket can
fully load
the unit
weight.
Shelf Setting Shelf Setting
Flat Width 100 mm
Flat
Concrete
Anchor Bolt
(M12)
Filled Mortar
Unit Base
Nut
Washer
B
e
low
Using this type of Anchor Bolts, be sure
to cut off the
○
A .
(Due to remove the pipe cover difficulty)
Outdoor Unit
Base Bracket
Width100mm
Flat recommended Size
：
SPHC
(Fielded supplied)
Unit
：
mm
Flat Thickness
：
4.5mm
排水孔 ( φ 26) 空氣吸入口
Drain Hole
(
Φ26)
Air Inlet