Hitachi RAC-F10CF, Руководство по эксплуатации

Страница: 16 / 62

– 16 –
MAINTENANCE
Before cleaning, stop operation and switch off the power supply.
1. PRE-FILTER
Clean the pre- fi lter, as it removes dust inside the room. In case the pre- fi lter is full of dust, the air
fl ow will decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to
clean the fi lter following the procedure below.
CAUTION
1
Open the front panel and remove the fi lter
2
Vacuum dust from the pre- fi lter and using
vacuum cleaner. If there is too much dust, rinse
under running tap water and gently brush it with
soft bristle brush. Allow
fi lters to dry in shade.
3
●
Set the pre- fi lter with “FRONT” mark facing
front, and slot them into the original state.
●
After attaching the pre- fi lters, push the front
panel at three arrow portions as shown in
fi gure and close it.
CAUTION
●
Do not wash with hot water at more than 40°C. The fi lter may shrink.
●
When washing it, shake off moisture completely and dry it in the shade; do not expose it directly
to the sun. The fi lter may shrink.
●
Do not use detergent on the air cleansing fi lter as some detergent may deteriorate the fi lter
electrostatic performance.
!
!
(EN3) RAS-F10CF 16 (EN3) RAS-F10CF 16 3/10/15 3:04 PM 3/10/15 3:04 PM