Hitachi RAC-10SH2, Инструкция по эксплуатации

Страница: 20 / 96

DYNAMIC AIR DEFLECTION FUNCTION (TRACING/EVASION)
The infrared sensor can detect the position of people and automatically change the airflow direction.
Press the AUTO AIR DEFLECTION button to switch the air deflection
mode.
ƽ H ow to change the d etection spee d of the sensor of the dy na m ic air d eflection ( tracing/e v asion ) function :
e There are 2 detection speeds: “Standard” (by intervals of 15"–3') and “Slow” (by intervals of 1'–10').
e The remote controller is set to the standard speed by default.
e When the detection speed of the sensor is too high, set the detection speed to “Slow”
(when people and pets in the room behave frequently, resulting in frequent changes to the airflow direction).
e
After the dynamic air deflection mode is set, the sensor usually works once every 15 seconds to 3 minutes to
detect the position of the person and adjusts the airflow direction accordingly.
(The airflow direction does not change with the movement of human body immediately.)
e
If the dynamic air deflection mode fails to achieve the desired effect, adjust the airflow direction manually.
e
When the machine works in cooling, dehumidifying, or dry cool operation after the dynamic air deflection is set,
if the indoor humidity/temperature is very high, the left/right/upper/lower air deflectors may change their angles
to prevent drop of condensed water. After the temperature falls, the air conditioner returns to the dynamic air
deflection status.
1
e
(Tracing) Adjusts the airflow direction
automatically to send the air flow to
the location of the person.
e (Tracing) Adjusts the airflow direction
automatically to keep the air flow away
from the location of the person.
e Return to the setting prior to the dynamic
air deflection mode.
Pressing the DYNAMIC
AIR DEFLECTION
button
Release the
Dynamic Air
Deflection button
Operation Description
Example: Heating
Hold down after the running stops
Select the desire setting.
(Finely tuned 3 to -3. The indicator turns off 10 seconds later)
Press the (STOP) button e The settings are saved.
Set the detection speed of the sensor to “Slow”.
After the running stops, hold down for more than 5 seconds while pressing and holding .
e
At this time, the air conditioner beeps for signal receiving.
e
Return to the “Standard” mode by repeating the above procedure (until the air conditioner beeps for
signal receiving).
In addition to “Standard” and “Slow” modes, you can also fine tune the detection speed of the sensor.
Fine tune the detection speed of the sensor
DEUTSCH
FRANÇAIS
IT
ALIANO
SP
ANISH
POR
TUGUÊS
∂ÏÏËÓÈο
РУССКИЙ
– 20 –
EN̲20.ai 2010-7-7 15:18:47
18SH3_OM.indd 20 2012-2-21 14:45:31