Hitachi RAC-10SH2, Инструкция по эксплуатации

Страница: 12 / 96

1
While (SAVE) is blinking, point the remote controller towards
the unit and press the (ON/OFF) button.
•
A short beep sounds and (SAVE) indicator turns on.
Press the (FUNCTION SELECTOR)
button until (SAVE) blinks.
Press the (FUNCTION SELECTOR) button again until
(SAVE) blinks.
While
(SAVE) is blinking, point the remote controller towards
the unit and press the (ON/OFF) button.
•
A short beep sounds and (SAVE) indicator turns off, indicates
the setting is released.
„
Notes for “ sa v e ” setting
•
If ampere is set to “Save”, the maximum heating capacity slightly lowers
and starting up of heating operation will take a little longer. Besides,
the preset temperature may not be reached if outside temperature is
low.
•
Point the re m ote controller to the signal recei v er of the unit
Signal reception distance is approximately 7m in front of the unit.
However, this distance may be shorter or the signal may not be
receivable if there is an electronic lighting device in the same room.
•
H an d le the re m ote controller with care
Dropping it or getting it wet may compromise its signal transmission
capability. After new batteries are inserted into the remote controller,
the unit require approximately 10 seconds before it can respond to
commands and begin operation.
WH EN OPERATING T H E REMOTE CONTROLLER
Approximately
7m from the front
PREPARE THE REMOTE CONTROLLER (continued)
A m pere setting ( Stan d ar d /Sa v e ) can b e selecte d .
If you experience frequent circuit breaker tripping, set ampere to “Save” to avoid this problem.
(Ampere is set to “Standard” at the time of purchase.)
4
2
RELEASE
– 12 –
EN̲12.ai 2010-7-7 15:11:17
18SH3_OM.indd 12 2012-2-21 14:45:26