57
Flashing pattern
Possible Cause
Check Point
Food etc. may come in contact with the ice
tray or the stored ice amount detection lever.
This fl ashing shows that there is a problem.
It will fl ash if you stop ice making during the
ice making process.
Door remains open for more than 1 minute. (ex:
door is not completely closed.)
It is in process of Ice Maker Cleaning.
The vacuum function may not work properly.
It may be in the operation check mode for
serviceman. (
※
1)
Empty the Ice Compartment and perform
"Cleaning the Ice Making".
Consult your dealer.
Check the points described in "Ice Tray" on
P.51.
Check the points described in "Door Alarm"
on P.58.
Check the points described in "How to
maintain the Automatic Ice Maker" on P.51.
Check the points described in "There is something
strange with the Vacuum Compartment" on P.55.
It will return to the normal mode after about 10
minutes. There is no problem with using.
"Check" fl ashing
3 times
"Check" fl ashing
(excluding fl ashing 3 times)
"Stop" fl ashing
All displays fl ashing
"Large"
"Normal"
"Stop"
Flashing
"Vacuum Compartment
Subzero"
or
"Vacuum
Compartment Chiller"
fl ashing
Check
Vacuum
Ice making
function
PRACTICAL ADVICE ON HOW TO USE THE REFRIGERATOR/REPLACEMENT PARTS
Replacement of the vacuum packing
●
Replace it if it is damaged.
●
Order information about replacement parts
REPLACEMENT PARTS
The "Check" display
fl ashes on the
Control Panel for
operation
The electric supply failed
The refrigerator is not expected
to use for a long term
Remove frost
When you want
to adjust the
temperature
more fi nely
●
This fl ashing shows that there is a problem with the Automatic Ice Maker, the temperature control device or
the frost removal device etc.
●
Consult your dealer if the fl ashing does not stop even after checking the point listed in the following table.
●
Reduce the number of times of opening and closing the door and avoid storing food additionally until the electric supply is restored.
●
Unplug the power plug and maintain the inner of the refrigerator and the Automatic Ice Maker, and leave all
the door open to dry the refrigerator for 2
〜
3 days.
Pg.49
〜
51
●
Any operation to remove frost is not required because this refrigerator remove frost automatically.
Thawed water is collected in the evaporating tray and automatically evaporates.
You can adjust "MIN"/"MID"/"MAX" more fi nely when setting the temperature
in the Refrigerator Compartment and the Freezer Compartment.
1. Open the Lower Freezer Door.
2. Push the Quick Cooling button on the control panel on the refrigerator door
for more than 5 seconds until single long beep sounds.
3. Push the Cooling button or the Freezing button to adjust the temperature.
The temperature becomes lower by 1 step every time you push the button.(If
you push the button when "MAX" is selected, the setting returns to "MIN".
）
4. If you want to stop the fi ne adjustment, perform the operation of 1 and 2.
Two beeps sound and You can set the temperature by normal step.
※
1 Pushing the button long (more than 10 seconds), the refrigerator may go into the operation check mode.
Temperature setting
Display ON
When replacing the following parts, make sure to tell your dealer the type name and buy the special parts.
Replacing the water fi lter
●
Replace the water fi lter when it becomes old.
(Replace it normally once 3
〜
4 years.)
●
Ordering the replacement water fi lter
Tell your dealer the parts number: RJK-30 to buy the
replacement water fi lter. (Ice making capacity is the
same with a water fi lter removed.)
MIN MID-
MIN
MID MID-
MAX
MAX
Flashing
Troubleshooting / Practical Advice on How to Use the Refrigerator / Replacement Parts
（低溫）
（低溫）
Parts number
R-S50AM 321
Type: R-S51AMJ
