Hitachi R-G670FJ, Как пользоваться инструкцией

Страница: 49 / 80

49
B
ef
o
re
U
se
Plug the power cord.
It is not a problem to plug in the power cord soon after installing the refrigerator.
Use a wall outlet exclusively when connecting the power cord. (Alternating current 110V, rated 15A or more)
●
Check that the power plug or the cord is not wedged between the back of the refrigerator and the wall in order to prevent the cord from getting hot.
4
●
If you wish to install the refrigerator in a hot spring area exposed to sulfide gas, you may need to apply anti-rust
treatment to the piping. Contact your dealer in advance. Failure caused by sulfide gas will not be covered under
guarantee.
● After inserting the power plug into a wall outlet, you will hear noise from the refrigerator, which is preparing for
operation. You may also hear a louder noise from the compressor or fan until the inside is cooled down enough.
●
It may smell of plastics in the beginning when you start to use. Keep the room well-ventilated.
Such smell will disappear gradually.
●
Do not peel off the seal on the back or plastics at the lower part of the side.
●
When a magnet or suction cup is attached on the side of the body or the surface of a door, it may
leave a mark.
●
When you attach a paper sheet on the door surface in a high ambient temperature, dew may
form on the door surface, or the paper may absorb moisture.
Notice
Cooling inside the refrigerator starts.
●
It may take more than 4 hours to cool well the inside of the refrigerator, depending on conditions such as the ambient
temperature or storage state of foods. It may
take 24 hours or more in summer, etc.
Do not put ice cream, uncooled foods or perishable foods in it until the inside of the refrigerator is cooled well.
●
Perform
“
製冰機清潔
” (Ice Maker Cleaning)
when using the automatic ice making function first. Pg.68
●
A series of ice making operation will start automatically after the inside of the refrigerator is cooled well.
(When using for the first time, it may take 24 hours and more to make ice .)
It is recommended to ground the refrigerator to prevent possible electrical shock.
●
Contact your dealer to ground the refrigerator or install an earth leakage circuit breaker if the refrigerator is installed in especially
damp and humid places.
Stickers
Plastic parts - Left/Right
Never connect the earth wire to the following places:
●
Water pipe (Danger of electrical shock)
●
Gas pipe (Danger of explosion)
●
Telephone line or earth of lightning rod (Danger when lightning strikes)
Earth terminal
Earth installation screws
Earth wire
(Copper wire with diameter of 1.6mm)
Place a sheet or cloth
for protection first, and
then lay it back to drain
water.
Take out foods or ice.
Remove the leg covers, and raise the
adjustable mounts.
Pour off the water from the water
supply container/ice tray.
Use a tape to secure the door/power
cord.
See “Preparation before use” for
installing the refrigerator in a new
location.
Pg.48
Pull off the power plug.
No problem just before move.
Place a sheet or cloth for protection
when moving / transporting it.
To prevent damage to the floor material or water from spilling out.
Make sure to hold the
handles when carrying it
with 2 persons or more.
Do not lay it down horizontally for
transportation (which may cause failure
of the refrigerator).
Transporting your refrigerator (transport for moving)
1
4
2
5
9
3
6
7
8
Such as old cloth