68
●
Before removing parts, take out all the foods on the parts.
●
Do not remove parts except the ones listed here.
Please contact with a Hitachi customer service centre for cleaning such parts after removing them.
HOW TO REMOVE/ATTACH PARTS
Caution
Height adjustable upper and middle shelf
(Glass shelf)
Door pocket
Fixed shelf
Vacuum Case
Height adjustable lower shelf
When installing the shelf, slide it until it reaches to the interior wall, then
slightly lift up the back of the shelf and push it in.
(hitch the forks of the shelf to the parts on the back of the shelf)
Slightly lift up the
back of the shelf
and draw it.
Lift up the door pocket while
tapping the left/right of its
bottom surface, and remove it.
(It is fixed a little tightly.)
Insert the door pocket fully to the end
when installing it.
Draw the shelf, and pull off the 2 pins on the
lower right and remove it.
Pull out the Vacuum Case by slightly lifting up
and moving up and down.
Insert the Vacuum Case so that both right and left
convex ribs on the case can slide under the guide
rail of the Vacuum Container.
Lastly, hold down the handle to lock.
How to remove
How to attach
Slightly lift up and pull out.
Raise the shelf as shown
in figure, and turn it and
remove it.
Forks of the
shelf (Right /
Left)
Forks
Door may damage if drawing the shelf without turning it.
Be careful to attach/remove the glass shelf because it is heavy.
If it drops, it may break and cause bruise or injury.
Caution
Tap
Tap
Guide rail
Vacuum Case
Vacuum Container
Convex rib
Check that it is fixed properly
by taking it in and out a few
times.
Request
If you pull out the shelf straight, it may hit the
door.
Caution
Caution
If it drops, it may break and cause bruise or injury.
