46
Cushion (Accessory)
Please arrange it as shown below
●
The floor should be sturdy and flat.
Lay a board with 1cm thickness on the floor if the refrigerator is installed on the carpet, tatami mat, flooring or PVC sheet flooring which
may be hollow or discolor.
●
Place the refrigerator away from direct sunlight and heat.
●
Do not place it in damp areas, and ensure good air ventilation.
This will reduce adverse effects to refrigerating power and keep electricity cost down. This will also
prevent the refrigerator from discoloring and rusting.
●
The place is separated from other equipment.
To prevent disturbance (noise / scattered image) to TV and others attributable to the refrigerator.
●
To cool efficiently, allow enough space around the refrigerator for radiating heat.
●
The actual size of the center part of the side of the refrigerator’ s main body is slightly larger than the
nominal size. Therefore, please allow enough space around when installing the refrigerator.
●
The back of the refrigerator can be placed very close to the wall. If any vibration sound occurs and/
or any discolor/dirt is found on the wall, move the refrigerator away from the wall.
Fix the refrigerator
The adjustable mounts, which are located in the front bottom corners of the refrigerator, can be adjusted by turning
them to level the refrigerator. (Make sure to use a supplied tool and 2 cushions)
Adjusting the refrigerator adjustable mount to keep it level
●
Left side or right side door may be slightly lower when the surface of the installation place is not level or either left or right leg sinks in
the floor surface because of the soft floor material and the addition of food weight.
→
This does not affect the refrigerator function. Adjust the refrigerator adjustable mount to keep it level according to the procedure listed
below if you want to correct it.
Correcting any left/right lean and lifting slightly the front side of the refrigerator until the door can close easily and completely.
BEFORE USE
Preparation before use
To remove leg cover, hold both
ends of it and pull it towards to
you by applying some force.
With the supplied tool, turn an adjustable mount on the side
so that the refrigerator is lower to make the Refrigerator
Compartment door level.
The height of the door can be adjusted 1mm every one turn of the adjustable mount.
Insert the left and right pins of the leg
cover into the mounting holes to attach
the leg cover.
It may be approx. 5 days before the refrigerator
conforms to the floor allowing the door to be
leveled. Readjustment is required if the door is not
leveled.
Place pads under the adjustable
mounts.
Place pads under the adjustable mounts
evenly so that they can be leveled.
Lower both adjustable mounts
(left and right) by turning them
to secure the refrigerator.
Clamp the supplied tool adjusting to
the shape of the adjustable mounts.
●
Always wipe the adjustable mounts and floor clean before placing pads. Adherents may scratch the floor if they remain.
●
Be careful not to scratch the floor with the supplied tool when turning the adjustable mount.
2
Leg cover
Adjustable mounts
Supplied tool (Accessory)
■
The left side of the door is lower.
■
The right side of the door is lower.
Turn the left Adjustable
mount to lower the left
side door.
Turn the right
Adjustable mount to
lower the right side
door.
Mounting hole
Fork
Leg cover
1
2
3
Required space for right and
left of the refrigerator: 1cm or more
Required space above the
refrigerator: 5cm or more
1
1
2
2
3
●
When you release your hand from the refrigerator door with the door open, the door may move, but this is normal.
Notice
