4-83
●
Set the print specifications
Adjust print parameters
2015.07.07 12:45
Com=0
[Stop
]
Character height
（
0
〜
99
）
Character width
（
0
〜
3999
）
Print start delay
（
0
〜
9999
）
SC
Pulse rate div. Factor
Message name [
]
−
＋
Change unit
Save
Back
−
＋
８５
−
＋
０００２
−
＋
００００
−
＋
００１
(1/1
〜
1/999 Enter
denominator.)
M
Manual
Startup
HOME
4.14.4 Fine adjust the print specifications (Adjust print parameters)
(1) Function
●
Starts from the Print description screen.
●
Current message print specifications "character height”, "character width", "print start delay" and "Pulse rate
div. Factor" settings are easily set.
●
Since changes to the set value are immediately reflected in the printing, the changes be easily confirmed while
printing.
●
After setting in character units or mm units, fine adjust in scan units.
●
When you want to input in mm units, input "Line speed" in the print specifications screen.
"Adjust print parameters" screen
(Note) If various settings are changed when the printing is performed frequently,
the faults such as "Print Overlap fault", "Print Data Changeover In
Progress V" or "Invalid Print Start Timing" may occur.
Reverse scan printing (RX2-S only)
●
Selects whether or not reverse scan control which deflects the particles in the reverse order of the
conventional order is to be used.
●
The printing tilt when the print target is transported at high speed becomes smaller than the
conventional control system.
Refer to "9. Appendix" of the Technicial manual for more information.
6
High quality mode (RX2-S only)
●
By using this function, better printing quality would be obtained than normal one particularly when
the product speed matching function is applied to print something at low speed, if a specific dot
pattern which lessens a distortion of printing is adopted.
Refer to "9. Appendix" of the Technical manual for more information.
7
