12
HAS-K252
(L) × 3
(N) × 1
6
Attach the bracket (B) to the LCD projector using four M4 × 8 (G) hexagon
head screws.
Tightening torque: 0.98 N•m (10 kgf•cm)
4
Attach the arm (M) to the base bracket (O).
Insert the tab at the top of the arm (M) in the groove at the top of the base bracket (O). Then insert the U-groove
at the bottom of the arm (M) in the groove of the vertical adjusting nut in the base bracket.
5
Use three M5 shoulder screws (L), three washers (P) and one M5 screw with
spring washer and flat washer (N) to secure.
Tightening torque: 0.98 N•m (10 kgf•cm)
(N)
(L) (P)
(P)
(P)
(G)
(B)
Note:
Be sure not to mix up
the screw types.
Note:
Make sure that the bracket
(B) is correctly oriented.
(L)
(L)
Projection
direction
Projection
direction
Projection
direction
Projection
direction
WARNING
■ Never use screws other than those designated.
Failure to heed this warning may cause the projector to fall or other hazard
resulting in damage or injury.
Place the tabs (rear of arm) in the grooves.
(O)
(M)
Note:
Insert the vertical adjusting
nut as shown in the fi gure.
Note:
Route the cables through this hole before
attaching the arm (M) to the base bracket (O).
13
HAS-K252
Note: This procedure is not required for 70 inches and larger projection screen sizes
(both 4:3 and 16:10 screens).
Note: The adjusting knobs
should face the direction
shown in the fi gure.
7
Attach the LCD projector to which the bracket (B) has been attached to the
adjusting block (Q).
Tighten the four M4 x 8 round head screws (H).
Tightening torque: 0.98 N•m (10 kgf•cm)
6
For projection screen sizes of less than 70 inches (both 4:3 and 16:10 screens),
remove the four dish screws (P) in the arm (M) and change the location of the
adjusting block (Q) as shown in the figure.
Tightening torque: 0.98 N•m (10 kgf•cm)
8
Connect the cables to the projector.
(B)
(Q)
(B)
(Q)
(H)
(LCD projector rear panel)
(LCD projector front panel)
Connect as shown in the above fi gure.
(H)
WARNING
■ Never use screws other than those designated.
Failure to heed this warning may cause the projector to fall or other hazard resulting in damage or injury.
Installing the bracket (continued)
(Q)
(P)
(P)
