--- 10 ---
(2) When replacing the Armature
[12] <12>
and the Ball
Bearing 608VVC2PS2L
[17] <17>
on the commutator side,
press inward on the Dust Seal
[16] <16>
while taking care
of its direction until the end face of the Dust Seal
[16] <16>
hits against the butting surface of the Armature
[12] <12>
and make sure that the Dust Seal
[16] <16>
cannot turn
freely. (See Fig. 9.)
The Dust Seal
[16] <16>
is an important element for
improved dust protection of the Ball Bearing 608VVC2PS2L
[17] <17>
. Be sure to use a new one at every disassembly
work of the Ball Bearing 608VVC2PS2L
[17] <17>
.
Fig. 9
Dust Seal
[16] <16>
Armature Shaft
Ball Bearing
608VVC2PS2L
[17] <17>
8-2. Reassembly
Put the parts together in the reverse order of disassembly, with the precautions given below.
(1) Generously lubricate the teeth of the Gear
[20] <20>
and the Pinion
[6] <6>
with grease. Rub grease onto the
teeth with your fingers so that the grease reaches each tooth bottom. Note that under-lubricated Gear
[20]
<20>
and Pinion
[6] <6>
may wear at a faster rate.
(4) [Only for U.K. (110 V)]
When connecting the Terminal
[46] <52>
to the internal wire (the middle wire among three) of the Noise
Suppressor
[40] <46>
, strip the insulation sheath on the itnernal wire by about 6 mm and press-connect it
together with the Terminal
[46] <52>
with a clamping tool available on the market. (See Fig. 10.)
Fig. 10
(3) Apply Three Bond TB 1406 Screw Locking Agent to the following screws.
Two Seal Lock Screws (W/Sp. Washer) M4 x 10
[18] <18>
which fix the Bearing Cover
[11] <11>
in place.
Three Seal Lock Screws (W/Sp. Washer) M4 x 8
[21] <21>
which fix Bearing Cover (B)
[22] <22>
in place.
Four Seal Lock Screws (W/Sp. Washer) M5 x 16
[26] <26>
which fix the Packing Gland
[25] <25>
in place.
Solderless connection
Содержание G 12SA3
Страница 26: ......
