67
CP-X2511N(C15I-25N2) / CP-X3011N(C15I-30N2) / CP-X4011N(C15I-40N2) / CP-X2011N(C15-20N2) / ED-X45N(C15-20N2)
Communicaion P
o
r
t
The following two ports are assigned for the command control.
TCP
#23
TCP
#9715
Configure the following items form a web browser when command control is used.
Port Settings
Network Control
Port1 (Port: 23)
Port open
Click the
[Enable]
check box to open
[Network
Control Port1 (Port: 23)]
to use
TCP
#23.
Default setting is “Enable”.
Authentication
Click the
[Enable]
check box for the
[Authentication]
setting when authentication
is required.
Default setting is “Disable”.
Network Control
Port2 (Port: 9715)
Port open
Click the
[Enable]
check box to open
[Network
Control Port2 (Port: 9715)]
to use
TCP
#9715.
Default setting is “Enable”.
Authentication
Click the
[Enable]
check box for the
[Authentication]
setting when authentication
is required.
Default setting is “Enable”.
Command Contr
ol via the Netw
or
k
When the authentication setting is enabled, the following settings are required.
Security Settings
Network Control
Authentication
Password
Enter the desired authentication password.
This setting will be the same for
[Network
Control Port1 (Port: 23)]
and
[Network
Control Port2 (Port: 9715)]
.
Default setting is blank.
Re-enter
Authentication
Password
Command Contr
ol via the Netw
or
k (continued)
Command contr
ol settings
[TCP
#23]
1. Command f
o
r
m
a
t
Same as RS-232C communication, refer to RS-232C Communicaton command format.
2. R
esponse code / Er
ror code
("h" shows hexadecimal)
Four of the response / error code used for
TCP#23 are the same as RS-232C
Communication (1)~(4). One authentication error reply (5) is added.
(1)
ACK reply : 06h
Refer to RS-232C communication
.
(2)
NAK reoly : 15h
Refer to RS-232C communication
.
(3)
Error reply : 1Ch + 0000h
Refer to RS-232C communication
.
(4)
Data reply : 1Dh + xxxxh
Refer to RS-232C communication
.
(5)
Authentication error reply : 1Fh + 0400h
When authentication error occurred, the projector returns the error code.
[TCP
#9715]
1. Command f
o
r
m
a
t
The commands some datum are added to the head and the end of the ones of
TCP#9715 are used.
Header
Data length
RS-232C command
Check sum
Connection ID
0×02
0×0D
13 bytes
1 byte
1 byte
[Header]
02, Fixed
[Data Length]
RS-232C commands byte length (0×0D, Fixed)
[RS-232C commands]
Refer to RS-232C Communication command format.
[Check Sum]
This is the value to make zero on the addition of the lower 8 bits from the header
to the checksum.
[Connection ID]
Random value from 0 to 255 (This value is attached to the reply data).
NO
TE
• Operation cannot be guaranteed when the projector receives an
undefined command or data.
• Provide an interval of at least 40ms between the response code and any
other code.
• Commands are not accepted during warm-up.
