-6-
Fig. 8 • Reassembly of gear cover (A) ass’y (with slip clutch)
Reassembly can generally be conducted by reversing the disassembly procedure. However, special
attention should be given to the following items.
1. Internal wire arrangement
(1) Perform wiring of the internal wires according to Fig. 11 to Fig. 16.
(2) Be careful not to get the internal wires caught between handle covers (A) and (B).
2. Reassembly of gear cover (A) ass’y
NOTE: Never reuse Ratchet (D) [8] removed from Spindle (A) [4]. If reused, the tightening torque
between Ratchet (D) [8] and Spindle (A) [4] will be excessively low and Spindle (A) [4] may
run idle in the IMPACT mode.
(1) Mount the Washer
[28]
to Ratchet (D)
[8]
securely before mounting the Low Speed Gear
[29]
.
(2) Mount the Shift Arm
[31]
and High Speed Gear
[30]
in the specified direction as shown in Fig. 8 to Fig.
10.
(3) Insert the Shift Pin
[22]
into the slotted hole of the Shift Arm
[31]
securely as shown in Fig. 10.
Reassembly
[30]
[4]
[26]
[5]
[24]
[9]
[8]
[7]
[6]
[29]
[21]
[32]
[31]
[14]
[15]
[28]
[13]
