(
1
)
Attaching the dust extractor system
(
Fig. 3
)
Terminal insertion
port of tool body
Rail section of
tool body
Protruding section of
dust extractor system
Latch
(
both sides
)
Fig. 3
CAUTION
To prevent accident, make sure to turn the switch
o
ff
, then disconnect the battery and the drilling
tool.
Place the dust extractor system on a stable platform,
and line up and insert the rail section of the tool
body into the protruding section of the dust extractor
system.
Fully insert the rail section of the tool body until the
tool body and the dust extractor system come into full
contact with each other, and ensure that the latches
on both sides of the dust extractor system are properly
and securely fastened.
(
2
)
Removing the dust extractor system
(
Fig. 4
)
2
1
Latch
(
both sides
)
Fig. 4
CAUTION
To prevent accident, make sure to turn the switch
o
ff
, then disconnect the battery and the drilling
tool.
Press the latches on both sides of the dust extractor
system, and remove the tool body from the dust
extractor system.
ASSEMBLY AND OPERATION
APPLICATIONS
Dust extractor system specialized for drilling concrete, for
use with the following Hitachi cordless rotary hammers:
DH18DBL / DH18DBDL / DH18DBQL / DH18DBML
DH36DBL / DH36DBDL / DH36DBQL / DH36DBML
DH36DPA / DH36DPB / DH36DPC / DH36DPD
NOTE
This dust extractor system is only to be used for
drilling concrete.
HOW TO USE
1. Attaching and removing the dust extractor
system (Fig. 2, 3, 4)
WARNING
●
When attaching, removing, or adjusting the dust
extractor system, in order to prevent an unlikely
accident, be sure to turn o
ff
the tool’s switch, and
remove the tool’s battery and tool bit. (Fig. 2)
Tool bit
(
drill bit
)
Battery
Fig. 2
●
Make sure the dust extractor system is fully
attached.
If not fully attached, the dust extractor system
could come loose and result in injury.
8
English
000Book̲Dust extractor system̲NA.indb 8
000Book̲Dust extractor system̲NA.indb 8
2017/12/05 13:42:57
2017/12/05 13:42:57
