-18-
Washer (B)
[23]
Projection
Projection
Recesses
Shift Arm
[16]
Shift Arm
[16]
Hole
Grooves
Mark
Ridge
Fig. 8
(i) Confirm the direction of the groove when installing Slide Ring Gear (B)
[19]
so that the groove faces
toward the Motor
[33]
. (See Fig. 7.)
(ii) Install Washer (B)
[23]
in the Rear Case
[14]
with the projections of Washer (B)
[23]
engaged with the
recesses in the Rear Case
[14]
, and then turn Washer (B)
[23]
clockwise until it can turn no further.
(See Fig. 8.)
(c) Install the Shift Arm
[16]
into the Rear Case
[14]
.
With the ridge at the Shift Arm
[16]
facing the Motor
[33]
side, first install them on the unmarked side of
the Rear Case
[14]
. Then insert the projections on the Shift Arm
[16]
into the holes in the Rear Case
[14]
and be sure to fit the projections into the grooves on Slide Ring Gear (B)
[19]
mounted inside the
Rear Case
[14]
. (See Fig. 9.)
(d) Install the Drill Chuck
[2]
.
Use special repair tool (J-342, Code No. 324-582) to install the Drill Chuck
[2]
, and then secure it with
the Special Screw (Left Hand) M6 x 23
[1]
.
(e) Install the Shift Knob
[38]
onto the Shift Arm
[16]
.
When installing the Shift Knob
[38]
onto the Shift Arm
[16]
, note that the "LOW" mark on the Shift Knob
[38]
faces the Motor
[33]
with the Shift Arm
[16]
engaged with the recess on the Shift Knob
[38]
.
Fig. 9
