--- 16 ---
(j) Install the Shift Knob [38] into the assembly reassembled in step (i).
When installing the Shift Knob [38] into the Shift Arm [19], note that the "LOW" mark on the Shift Knob [38]
faces the Motor [28] with the Shift Arm [19] engaged with the recess in the Shift Knob [38].
(k) Install the assembly reassembled in step (1) and the assembly reassembled in step (j) together.
(See Fig. 14.)
Fit the projection on the Motor Spacer [27] into the recess in the Rear Case [17] while ensuring that the
Shift Knob [38] is aligned with the positive side of the Motor [28] and turn the Motor Spacer [27] clockwise
when viewed from the rear of the Motor [28] until it can turn no further. During installation, make sure that
the pinion press-fitted onto the shaft of the Motor [28] and Planet Gear (A) Set (3 pcs.) [24] mesh properly.
Fig. 14
(4) Installation of the assembly reassembled in step (3) into Housing (A). (B) Set [32]
(a) Install the Pushing Button [36] into Housing (B) [32]. (See Fig. 15.)
(b) Install the assembly reassembled in step (3) into Housing (A) [32]. Note that the projections on the Front
Case [9] and the Motor Spacer [27] are engaged in the recesses in Housing (A) [32], and the projection on
Housing (A) [32] is engaged in the groove of the Cap [4]. (See Fig. 16.)
Projection
Recess
Fig. 15
[36]
[32]
Fig. 16
Projections
[32]
Groove
Projection
Recesses