1
Operating Tips
To ensure safe and satisfactory operation of your television, read this booklet carefully before attempting to use it.
Safety
To avoid any dangerous situations and operating faults, do not place anything on top of the television and leave a space
of at least 10cm around the set.
If your television fails to operate correctly after normal warm-up time or during use, switch off, remove the plug from
the power point and call a service engineer.
Always situate your television on a solid and steady surface (or on a suitable stand). If you do not intend using a stand,
you are advised to fit the self-adhesive foot-pads supplied with the television to protect the surface upon which it is to
be placed.
Standby
To save energy and preserve optimum picture quality (by de-magnetizing the tube), you are advised to switch off your
television at the on/off switch when not in use.
Installation Procedure
1.
Connect your aerial to the TV at the rear of the cabinet (if it is an indoor aerial, in certain
reception conditions it may not provide the best picture. Adjust the aerial position for the best
result or use an external aerial).
2.
The proximity of mountains or high buildings may be responsible for ghost pictures, echoes or
shadows. If this is the case, change the orientation of the aerial.
3
Remove the battery cover. Install the two AA type batteries supplied into the hand unit according to the diagram inside the
battery compartment. Replace the battery cover.
♦
Always use batteries that are guaranteed against leakage.
♦
Never leave discharged batteries in the hand unit.
♦
Always change BOTH batteries when necessary.
4
Connect your TV to a 220 - 240VAC, 50Hz power socket. Switch on your TV with the switch marked on the front panel.
The red LED ‘on’ indicator will illuminate shortly after, followed by a programme number on the screen as it lights up. Press
the same switch again when you want to switch off.
Getting Started Using the Menus
Coloured Keys
Located on your hand unit are four coloured keys normally used for TOP Videotext
operation in videotext mode. With this television they are also used for accessing menu
information whilst in picture mode.
Using the Menus
Your TV is controlled using four menus accessed by using the coloured keys on the hand
unit. The menus will automatically clear if no command is received within 21 seconds.
The green
key gives access to the
PICTURE
menu.
Functions such as brightness, contrast and colour can only be
Red
Green Yellow Blue
adjusted using the menu system.
The yellow key gives access to the
PROGRAMME
menu.
The blue
key gives access to the
FEATURES
menu.
When you have accessed a menu you will need to move the blue cursor to highlight the
operation you want to perform using the four arrow keys.
Use the following keys to move the cursor:
Press the key marked P– to move the cursor down.
Press the key marked P+ to move the cursor up.
Press the key marked – to move the cursor to the left or to
adjust settings.
Press the key marked + to move the cursor to the right or to
adjust settings.
Whenever you want to exit a menu and return to your programme
press the key marked , (picture key).
P+
P–
