53
Operating
The PbyP / PinP is a function for displaying two different picture signals on a
screen that is separated into main and sub areas for each signal.
PbyP (Picture by Picture) / PinP (Picture in Picture)
PbyP
button
• If the
LAN
port is selected when the
PbyP
button is pressed, input
from other port is displayed on the main area.
• When in the PbyP / PinP mode, use the
MENU
button on the remote control
or ▲/▼ buttons on the control panel to display the OSD menu.
• There are certain functions that cannot be used when in the PbyP / PinP mode.
• A message will be displayed when buttons that cannot be used are pressed
(
116
). However, note that there are certain unusable buttons for which
messages are not displayed.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
NOTE
Normal mode
PbyP mode
main
area
sub
area
(continued on next page)
PinP mode
Press the
PbyP
button on the remote control. This acctivates the PbyP mode.
Then, press the
PbyP
button again. The projector goes into PinP mode. The
screen displayed before the
PbyP
button was pressed will be displayed as the
main area. Most of operations are effective for the main area only. Only outputs
the audio input signal paired with the picture input signal for the main area.
To quit the PinP mode, press the
PbyP
button again.
ð
ð
main
area
sub area