After making sure that the projector has cooled adequately,
slowly flip over the projector, so that the bottom is facing up.
7
Lamp
Lamp
WARNING
The projector uses a high-pressure mercury glass lamp made of
glass. The lamp can
break with a loud bang, or burn out
, if jolted or scratched,
handled while hot, or worn over time. Note that each lamp has a different lifetime, and
some may burst or burn out soon after you start using them. In addition, when the bulb
bursts, it is possible for
shards of glass
to fly into the lamp housing, and for
gas
containing mercury
to escape from the projector’s vent holes.
•
Please carefully read the section “Lamp” of “User’s Manual – Safety Guide”.
• Do not open the lamp cover, if the projector is mounted on the ceiling, or if the lamp
has broken. Ask your dealer to replace the lamp.
• Before replacing the lamp, make sure the power switch is off and the power cable is
not plugged in, then wait at least 45 minutes for the lamp to cool sufficiently.
• Use the lamp of the specified type only.
Type number: DT00581
(sold separately)
Do not use old (used) lamps; this is a cause of breakage.
CAUTION
• Do not reset the lamp timer without replacing the lamp.
Replacing The Lamp
If the indicators or a message prompts you to replace the lamp, replace the lamp
as soon as possible.
1
Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at
least 45 minutes.
2
Contact your local dealer to prepare a new lamp. Tell the dealer your lamp type number.
If the projector is mounted on the ceiling, or if the lamp has broken, also ask the dealer
to replace the lamp.
3
4
Hold the release button while sliding and taking the lamp
cover up.
5
Unscrew the 2 screws, and slowly pick up the lamp by the
handles.
6
Insert the new lamp, and tighten the 2 screws firmly to lock
it in place.
7
Slide the lamp cover into place until it locks into position.
8
Slowly turn the projector so that the top is facing up.
9
Turn on the projector, and reset the lamp timer. When the lamp has been replaced after
the message of "THE POWER WILL TURN OFF AFTER 0hr." is display, complete the
following operation within 10 minutes of switching power on.
(1) While the projector running, press the MENU button to open the menu.
(2) Choose the “OPTION” on the menu using the
/
button, then press the
button or ENTER button.
(3) Choose the “LAMP TIME” using the
/
button, then press and hold the
button of
projector or the RESET button of remote control for 3 seconds.
(4) Choose the “RESET” using the
button.
Lamp cover
Release
button
Handles
Screws
In the case of replacement by yourself,
