Hitachi CC 14, Инструкция по эксплуатации и правила безопасности

Страница: 9 / 52

English
9
STANDARD ACCESSORIES
q
Cut-Off Wheel 14"
×
7/64"
×
1"(355
×
2.8
×
25.4 mm)
Model CC 14 (A36RBIG) 1pc. (Code No.964975Z)
(Attached to the main body)
w
Spanner
Fig. 3
WARNING:
The use of attachment or accessories not recommended in this manual
may be hazardous.
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
Install the machine on a level flat place, and keep it in a stable condition.
2. Extension Cord.
To use the power tool when no suitable power
source is nearby, use an extension cord of
suitable size to ensure safety, and to prevent
power loss and overheating.
Determine from the accompanying table the
required extension cord wire size.
Check power cord and extension cords for loose
or exposed wires and damaged insulation,
before using.
Repair or replace as needed, before using the
power tool.
NOTE: The lower the wire size number, the heavier the wire, and the farther it will carry
current without a voltage drop.
WARNING:
Never connect this unit to an electrical power source until all operating
instructions have been read and understood.
3. Take off the chain.
As the movable part is pulled down by a chain when shipping out, slightly push the
handle down and take off the chain from the handle.
Ampere rating
12.1 to 16.0
(on nameplate)
Ext. cord length
Wire gauge size
A.W.G (mm 2 )
25 ft 14 A.W.G
(7.5 m) (2.0 mm 2 )
50 ft. 12 A.W.G
(15 m) (3.5 mm
2
)
100 ft. Not
(30.5 m) recommended