54
ADDENDA
A guide to simple problem solving
g
Before calling up the service personnel, please check the following chart for a possible cause to the problem you are encountering.
The following phenomena are not failures:
˄
1
˅
The picture will appear after a while when the power is on.
˄
2
˅
The cabinet clicks. The clicking is a creaking sound produced when the cabinet expands or contracts
due to changes in temperature.
˄
3
˅
Unevenness in color sometimes develops in part of the screen. Such unevenness in color may occur
depending upon the nature or setting of the picture. The proper color may be restored by reducing the
contrast or adjusting other settings.
˄
4
˅
The TV set can generate sound distortion in external devices such as a radio. Please separate radio equipment
from the TV set to a considerable distance.
Accessories
Symptom Possible
causes
No picture,no sound,power/standby indicator is OFF.
g
The power cord is not plugged in.
No picture,no sound,power/standby indicator is ON.
g
The TV is in standby mode.
No sound
g
The volume control is set to minimum.
g
The
Speaker
option in
Setup
menu is set to
Off
.
Twist image and poor sound
g
The antenna signal is too weak or too strong.
g
The TV is not tuned correctly.
Poor brightness, color or tint
g
The contrast, brightness, color or tint may be misadjusted.
Snowy picture
g
Interference from motorcycles, high-tension line, electric hair drier,
personal computer or radio station.
Ghosts
g
Check the direction, height or position of the antenna.
No color
g
The antenna signal is too weak.
g
Color System
or
Sound System
is not set properly.
Remote controller does not work.
g
The batteries in the remote controller may be exhausted.
g
The batteries may be improperly installed.
g
There is obstruction between the remote controller and the TV.
No.
Description
Quantity
C43-FD7000
C50-FD7000
1
Instruction manual
1
Yes
Yes
2
Remote control unit (CLE-959)
1
Yes
Yes
3
Battery (For CLE-959)
2
Yes
Yes
4
IR BLASTER cable
2
Yes
Yes
5
Caster holder
4
Yes
Yes
6
Antenna adapter
1
Yes
Yes
HITACHI Projection Television incorporates advanced power surge protection technology designed to protect against
component or circuit damage due to external or internal power surges.
If your TV appears
A LOSS OF POWER
, please follow the following procedure:
1. Press the
POWER
button once.
2. If there is still no power, wait for 30 seconds and press the
POWER
button again.
3. If there is still no power, unplug the power cord from the wall outlet. Wait for 30 seconds and plug the power cord in. Press
the
POWER
button again.
The protective technology should provide you for years of lasting entertainment from your HITACHI Projection Television.
