Hitachi C10LA - 10" Cabinet Saw, Инструкция по эксплуатации

Страница: 21 / 76

– 21 –
English
COMPOUND MITER CROSSCUTTING (FIG. Y)
This sawing operation is combining a miter angle with a
bevel angle.
Always work to the right side of the blade during
this type of cut. The miter gauge (3) must be in the
right side groove because the bevel angle may
cause the blade guard to interfere with the cut if
used on the left side groove.
When tilting the workpiece to 45° and push it toward
the blade, the blade guard may hit the blade. To
avoid injury, stop the work at that time.
work work
1. Set the miter gauge (3) to the desired angle.
2. Place the miter gauge (3) in the right side groove (2)
of the table.
3. Set the blade (1) bevel to the desired bevel angle
and tighten the blade bevel lock knob.
4. Hold workpiece fi rmly against the face of the miter
gauge (3) throughout the cutting operation.
Fig. Y
MITER CUT (FIG. Z)
This sawing operation is the same as crosscutting
except the miter gauge is locked at an angle other than
90°.
1. Set the blade (1) to 0° bevel angle and tighten the
blade bevel lock knob.
2. Set the miter gauge (3) at the desired miter angle
and lock in position by tightening the miter gauge
locking handle.
3. Hold the workpiece (2) fi rmly against the face of the
miter gauge throughout the cutting operation.
Fig. Z
WARNING
2
1
3
1
2
3
AUXILIARY FENCE (FIG. AA)
Making the base:
• Start with a piece of 3/8” plywood at least 5-1/2” wide
or wider and 30” long or longer.
• Cut the piece to shape and size shown:
Making the side:
• Start with a piece of 3/4” plywood at least 2-3/8” wide
or wider and 27” long or longer.
• Cut the piece to shape and size shown:
Putting it together:
• Put the pieces together, as shown:
Make sure the screw heads do not stick out from the
bottom of the base, they must be fl ush or recessed.
The bottom must be fl at and smooth enough to rest
on the saw table without rocking.
Fig. AA
30” 30”
2-5/8” 2-5/8”
3-1/2”
3/8” Thick plywood base
27” 27”
3/4” Thick plywood 3/4” Thick plywood side
5-1/2”
2-3/8”
4-3/4” 4-3/4” 4-3/4” 4-3/4” 4-3/4” 4-3/4”
1-1/4” 1-1/4” 1-1/4”
WARNING