Hitachi C 10RD, Инструкция по эксплуатации и правила безопасности

Страница: 3 / 45

– 3 –
English
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 230 Volt operation. It must be connected to a 230 Volt / 6.5 Ampere
time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way. Before using your table saw, it is critical that you read and understand these safety rules.
Failure to follow these rules could result in serious injury to you or damage to the table saw.
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such as
dust masks that are specially designed to filter out microscopic particles.
PRODUCT SPECIFICATIONS
MOTOR SAW
Type ........................................ Universal Table Size with Extension................. 970mm x 890mm
Amps ....................................... 6.5A Table Extension ................................ Left, Right, Rear
Voltage .................................... 230V/50Hz Rip Capacity with Extension.............. 130mm R x 185mm L
Watts ....................................... 1600W (S6, 25%,10min) Blade Size......................................... 250mm
No load speed ......................... 4800min -1 Rip Scale .......................................... YES
Overload Protection ................ YES Rip Fence ......................................... YES
Mitre Gauge ...................................... YES
Maximum Cut Depth @ 90 º .............. 73mm
Maximum Cut Depth @ 45 º .............. 63mm
Net Weight ........................................ 21.65kg
WARNING
WARNING
Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the
EQUIPMENT. This can influence other equipment (e.g. blinking of a lamp). If the MAINS-IMPEDANCE Zmax <
0.3 OHM, such disturbances are not expected. (In case of need, you may contact your local supply authority
for further information).
Wear safety goggles
Wear ear protection
Wear a breathing mask
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, hoses and packaging should be
sorted, taken to the local recycling center and disposed of in an
environmentally safe way.
V........... Volts A............ amperes
Hz......... hertz W........... watts
min....... minutes ~............ alternating current
h........... hours ........... class II Construction
I............ ON O........... OFF
min
-1
..... revolutions per minute
SYMBOLS
WARNING
Noise can be a health hazard. When the noise level exceeds 85dB(A), be sure to wear ear protection.