Hitachi 55293DLB, Руководство по обслуживанию, Страница: 47 / 86

46

SI Input
o
Serial Data Input

SO Output
o
Serial Data Output

PACKAGE
o
28-pin SOP (330mil)
General Description
The MX25L1602 is a CMOS 16,777,216 bit serial Flash EEPROM, which is configured as 2,097,152 x 8
internally. The MX25L1602 features a serial peripheral interface and software protocol allowing operation on a
simple 3- wire bus. The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data
output (SO). SPI access to the device is enabled by CS input.
The MX25L1602 provide sequential read operation on whole chip. The sequential read operation is executed
on a segment (512 byte) basis. User may start to read from any byte of the segment. While the end of the
segment is reached, the device will wrap around to the beginning of the segment and continuously outputs data
until CS goes high.
After program/erase command is issued, auto program/ erase algorithms which program/erase and verify the
specified page locations will be executed. Program command is executed on a page (128 bytes) basis, and erase
command is executed on both chip and sector (8K bytes) basis.
To provide user with ease of interface, a status register is included to indicate the status of the chip. The
status read command can be issued to detect completion and error flag status of a program or erase operation.
When the device is not in operation and CS is high, it is put in standby mode and draws less than 30uA DC
current.
The MX25L1602 utilizes MXIC's proprietary memory cell which reliably stores memory contents even after
100,000 program and erase cycles.
Figure: Pin configuration