6
English
STANDARD ACCESSORIES
1. Box Wrench (for securing cutter blade) ............. 1
2. Set Gauge (for adjusting cutter height) .............. 1
3. Guide (with set screw) ........................................... 1
4. Blade Sharpening Ass'y
(for Resharpenable Blade Type) .......................... 1
Standard accessories are subject to change without no-
tice.
OPTIONAL ACCESSORIES (sold separately)
1. Dust collection adapter
Optional accessories are subject to change without no-
tice.
APPLICATIONS
䡬
Planing various wooden planks and panels.
(See
Fig. 1-4
)
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized con-
forms to the power requirements specified on the
product nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4.
Prepare a stable wooden workbench suitable for
planing operation. As a poorly balanced workbench
creates a hazard, ensure it is securely positioned
on firm, level ground.
PLANING PROCEDURES
1. Adjusting the cutter depth:
(1) Turn the knob in the direction indicated by the
arrow in
Fig. 5
(clockwise), until the triangular mark
is aligned with the desired cutting depth on the
scale. The scale unit is graduated in millimeters.
(2) The cutting depth can be adjusted within a range
of 0-1mm.
2. Surface cutting
Rough cutting should be accomplished at large
cutting depths and at a suitable speed so that
shavings are smoothly ejected from the machine.
To ensure a smoothly finished surface, finish cut-
ting should be accomplished at small cutting depths
and at low feeding speed.
3. Beginning and ending the cutting operation:
As shown in
Fig. 6
, place the front base of the
planer on the material and support the planer
horizontally. Turn ON the power switch, and slowly
operate the planer toward the leading edge of the
material. Firmly depress the front half of the planer
at the first stage of cutting, as shown in
Fig. 7
,
depress the rear half of the planer at the end of
the cutting operation. The planer must always be
kept flat throughout the entire cutting operation.
4. Precaution after finishing the planing operation:
When the planer is suspended with one hand after
finishing the planing operation, ensure that the
cutting blades (base) of the planer do not contact
or come too near your body. Failure to do so could
result in serious injury.
CARBIDE BLADE ASSEMBLY AND DISAS-
SEMBLY AND ADJUSTMENT OF CUTTER
BLADE HEIGHT (FOR DOUBLE EDGED BLADE
TYPE)
1. Carbide blade disassembly:
(1) As shown in
Fig 8
, loosen the blade holder with
the attached box wrench.
(2) As shown in
Fig 9
, remove the carbide blade by
sliding it with the attached box wrench.
Voltage (by areas)*
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
Power Input
570W*
Cutting Width
82mm
Max. Cutting Depth
1mm
Weight (without cord and guide)
2.5kg
No-Load Speed
15000/min
* Be sure to check the nameplate on product as it is subject to change by areas.
PRECAUTIONS ON USING PLANER
䡬
Do not use the Planer with the blades facing upward
(as stationary type planer).
SPECIFICATIONS
