Hitachi Koki NV 65AH, Инструкция и руководство по безопасности

Страница: 12 / 52

— 12 —
English
NOTE: Before loading nails in the magazine, adjust the
nail holder. If the magazine cover is forcibly
closed without adjusting the nail holder correctly,
the nail holder may be damaged.
(3) Place the nail coil in the magazine.
Insert the first nail into the magazine opening.
(4) Close the magazine cover.
(5) Grip the nail guide and knob with finger.
Press the knob down and swing the nail guide open.
(6)
1
Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Top of the Nail
Holder
Holder Shaft
1-1/2" (38mm)
1-3/4" and 2" (45,50mm)
2-1/4", 2-3/8"
and 2-1/2" (57,60,64mm)
Nail Holder
1
2
3
2
4
Driving Hole
Guide Slot
First Nail
Nail guide
Guide Surface
Pawl
Feeder
Knob
Nail Guide
First Nail
Magazine Opening
First Nail
Magazine
Magazine Opening
Nail
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide
surface.
Otherwise, the nail guide will not close correctly.
4
Pulling the nails to the right, swing the nail guide
closed.
(7) Lock the knob completely.
NAILER OPERATION
Read section titled “SAFETY”(pages 4 – 6).
DANGER
䢇
Operators and others in
work area MUST wear
safety glasses with side
shields which conforms
to ANSI Z87.1
specifications.
WARNING
䢇
NEVER point tool at yourself or others in work area.
䢇
Keep fingers AWAY from trigger when not driving
nails to avoid accidental firing.
䢇
Choice of triggering method is important.
Please read and understand “METHODS OF
OPERATION” found below.
䢇
Never place your hands or feet closer than 8
inches (200 mm) from firing head when using.
䢇
Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
䢇
In order to avoid double fire or unwanted ejection
of a nail due to bouncing of the Nailer.
1) do not push Nailer on workpiece with strong
force;
2) take Nailer away from workpiece using recoil;
3) release trigger quickly when performing trigger
fire.