Hisun SECTOR 1000, Руководство пользователя

Страница: 42 / 75

Periodic Service
6-15
EVERY 2 YEARS
■
Changing Brake Fluid
Consult your local Dealer for this service.
(See “Checking Brake Fluid Level” in “DAILY
CHECK” in “PERIODIC SERVICE” section.
■
Flushing Cooling System and Changing
Coolant
CAUTION
To avoid personal injury:

Do not remove the radiator cap while
coolant is hot. When cool, slowly rotate
cap to the first stop and allow sufficient
time for excess pressure to escape before
removing the cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain
plug and remove radiator cap. The radiator
cap must be removed to completely drain the
coolant.
3. After all coolant is drained, close the drain
plug.
4. Fill with clean water and flush with cooling
system cleaner.
5. Follow the directions on the cleaner container.
6. After flushing, fill with clean water and anti-
freeze until the coolant level is just below the
radiator cap. Install the radiator cap securely.
7.
Fill with fresh water up to the “FULL” mark on
the recovery tank.
8. Start and operate the engine for few minutes.
9. Stop the engine and let cool.
10. Check coolant level of recovery tank and add
coolant if necessary .
Coolant capacity 4.0L (4.2U.S.qts.)
① Recovery tank ②
“ FULL”
③
“ LOW”
IMPORTANT:

Do not start the engine without coolant.

Use clean, fresh water and anti-freeze to fill
the radiator and recovery tank.

When the anti-freeze is mixed with water, the
antifreeze mixing ratio must be less than 50%.

Securely tighten radiator cap. If the cap is
loose or improperly fitted, water may leak out
and the engine could overheat.
■
Anti-Freeze
CAUTION
To avoid personal injury:

When using antifreeze, put on some protection
such as rubber gloves. (Antifreeze contains
poison.)

. If you ingest antifreeze, follow the emergency
instructions on the antifreeze container and
seek medical attention.

When antifreeze comes in contact with the skin
or clothing, wash it off immediately.
。