Hisun Motors HS5D-EV, Руководство пользователя

Страница: 33 / 76

33
(0x2790,1) is less than BDI
Cutout level (0x2C30,4)
45C3 Low Battery Cut
Battery voltage (0x5100,1) is
less than Under Voltage limit
(0x2C02,2) for longer than the
protection delay (0x2C03,0)
45C4 High Battery Cut
Battery voltage (0x5100,1) is
greater than Over Voltage limit
(0x2C01,2) for longer than the
protection delay (0x2C03,0)
45C5 High Capacitor Cut
Capacitor voltage (0x5100,3) is
greater than Over Voltage limit
(0x2C01,2) for longer than the
protection delay (0x2C03,0)
45C6 Vbat below rated min
Battery voltage (0x5100,1) is
less than rated minimum
voltage for controller for longer
than 1s.
NOTE: This fault is sometimes
seen at power down.
45C7 Vbat above rated max
Battery voltage (0x5100,1) is
greater than rated maximum
voltage for controller for longer
than 1s.
45C8 Vcap above rated max
Capacitor voltage (0x5100,3) is
greater than rated maximum
voltage for controller for longer
than 1s.
45C9 Motor in low voltage cutback
Motor control (DC link) has
entered low voltage cutback
region.
45CA Motor in high voltage cutback
Motor control (DC link) has
entered high voltage cutback
region.
45CD KL15/30 Too Low
The voltage applied to the
KL15/30 is below the controller
rated minimum
4601 Device too cold
Low heatsink temperature
(0x5100,4) has reduced power
to motor
4602 Device too hot
High heatsink temperature
(0x5100,4) has reduced power
to motor
0x4603 Motor in thermal cutback
High measured (0x4600,3) or
estimated (0x4602,8) motor
temperature has reduced power
to motor
4604 Motor too cold
Low Measured temperature has
reached -30deg
4681 Unit in preoperational
Controller is in pre-operational
state
4682 IO can't init
Controller has not received all
configured RPDOs at power up
4683 RPDO Timeout (warning)
One or more configured RPDOs
not received with 3s at start up
or 500ms during normal