Hisense RB327N4WB1, Руководство пользователя

Страница: 17 / 22

Cleaning and care
surface.
-Don't use Thinner, Car detergent, Clorox,
ethereal oil, abrasive cleansers or organic
solvent such as Benzene for cleaning.
They may damage the surface of the
appliance and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. Wipe the inside of the fridge
freezer with a weak solution of
bicarbonate of soda, and then rinse with
warm water using a wrung-out sponge or
cloth. Wipe completely dry before
replacing the shelves and baskets.
Thoroughly dry all surfaces and
removable parts.
Although this appliance automatically
defrosts, a layer of frost may occur on the
freezer compartment's interior frequently
or kept open too long. If the frost is too
thick, choose a time when the supply of
food stocks are low and proceed as
follows:
1.Remove existing food and accessories
baskets,
For hygienic reasons the appliance
(including exterior and interior
accessories) should be cleaned regularly
(at least every two months).
Caution!
Danger of electrical shock! Before
cleaning switch the appliance off and
remove the plug from the mains socket.
The appliance must not be
connected to the mains during cleaning as
there is a danger of electrical shock.
Exterior cleaning
-Wipe the control panel with a clean, soft
cloth.
-Spray water onto the cleaning cloth
instead of spraying directly on the surface
of the appliance. This helps ensure an
even distribution of moisture to the
surface.
-Clean the doors, handles and cabinet
surfaces with a mild detergent and then
wiped dry with a soft cloth.
Caution!
-Don't use sharp objects as they are likely
to scratch the
Replacing the LED light:
Warning: The LED light should be
replaced by a competent person! If the
LED light is damaged, contact the
customer helpline for assistance.
unplug the appliance from the mains
power and leave the doors open. Ventilate
the room thoroughly to accelerate the
thawing process.
2. When defrosting is completed, clean
your freezer as described above.
Caution!
Don't use sharp objects to
remove frost from the freezer
compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back into
the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
food and drinks can cause seals to stick
to the cabinet and tear when you open the
door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly
after cleaning.
Caution!
Only after the door seals are
completely dry should the appliance be
powered on.
17
To
replace the LED light, the below steps
can be followed:
1.Unplug your appliance.
2.Remove light cover by pushing up
and out.
3.Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
correctly in place.
4.Replace LED light and snap it