9
purchase a water purifying system to do
that.
In order for the
water dispenser/ice maker
to
operate properly, a water pressure of
207-862 kPa
is required.
Warning:
The water connection must be made by a
qualified plumber. Operation outside the
water
pressure
range
may
cause
malfunction, severe and damaging water
leaks.
Under normal conditions, a 200ml (5.75
oz.) cup can be fill in about 10 seconds.
If the refrigerator is installed in an area
with
low
water
pressure
(blow
207kPa),you can install a booster pump to
compensate for the low pressure.
After you have connected the water line,
make sure the water storage tank inside
the refrigerator is properly filled. To do this,
press the water dispenser lever until the
water runs from the water outlet.
Parts for water line installation
The tools you will need
：
：
：
：
Spanner
(Provided)
Philips screwdriver
(Not provided)
Connecting to the water supply line
The connector and the check valve are
provided as one part. You should use the
new connector incidentally but not the old
one you have.
Caution!
The water line must be
connected to the cold water pipe.
First, turn off the main water supply line.
Screw the adaptor onto a suitable 3/4
”
BSP connector water outlet and use the
spanner to tighten it. Fully insert the water
line into the check valve. Then insert the
clip in the install pack as the figure shown
below.
To prevent the clips loose, use the valve
seat to hold it. Then use the screw to hold
the valve seat with Philips (+) screwdriver.
Note:
Use only the new tubings supplied with
the refrigerator. Old tubings should not be
used.
After connected to the water supply line,
please open the water valve to flush the
filter for 5 minutes before use.
If the main supply line is too far away
from the refrigerator to be connected to
the filter inlet line, the water line
（
5m
）
provided may be helpful. The outlet line of
the water filter should be connected with
