- 28 -
Table 3.5 Set remote server IP address and port number with key (continue)
3
·As above.
4
·As above.
NO.
·Press Up (SW5) or Down (SW8) until it displays “SP.”.
·In “SP.” Menu, press Select key (SW7) and confirm to enter remote server port
setting mode.
·After set, press Eject/Switch key (SW6) to exit.
·Press SW7 so that the port number becomes editable, flashing in 1Hz.
1
·The port number is 3 digits low, decimal values, port number range [high and low
combination]:0
～
65535.
2
·The port number is 2 digits high, decimal values, port number range [high and low
combination]:0
～
65535.
3.1.7 Subnet Mask Setting
Refer to the login interface in Figure 3.3 and enter, click <Network Setting> and enter IP setting interface. Directly set
subnet mask <LAN Net Mask>.
You can also spot check and set the subnet mask through key + digital tube. Press SW6+SW7 key at the same time for 3s
and enter the setting mode, as shown in below Table 3.6.
Table 3.6 Set subnet mask with key
NO.
·Press Up (SW5) or Down (SW8) until it displays “SU.”.
·In “SU.” Menu, press Select key
（
SW7
）
and confirm to enter subnet mask setting
mode.
·After set, press Eject/Switch (SW6) key to exit.
·Press SW7 so that the subnet mask number becomes editable, flashing in 1Hz.
1
·In menu, press Select key (SW7) so that the default number flashes and becomes
editable.
·Press Eject/Switch key (SW6) to switch flashing, and change editable area.
·Press Up (SW5) or Down (SW8) to change the number.
2
·As above.
3 Configuration of Modbus Adapter