8
Installation PTN-2-C37.94 with E1/PTN-2-C37.94 with T1
Release 01 02/2018
2.
MODULE DESCRIPTION
2.1
Front Panel
Figure 2
Front Panel
2.1.1
Handle
a.
Insert the Module into the Node
Take the front panel handles to insert or slide the module into the Dragon PTN node. Push
the module thoroughly into the node’s backplane. Next, tighten the two fastening screws in
the front panel corners.
b.
Remove the Module from the Node
Untighten the two fastening screws in the front panel corners. Take the front panel handles
to pull out and finally remove the module from the Dragon PTN node.
2.1.2
LEDs
The meaning of the LEDs depends on the mode of operation (= boot or normal) in which the
2-C37.94 module currently is running. After plugging in the module or rebooting it, the
module turns into the boot operation, see Table 2. After the module has gone through all
the cycles in the table below (=rebooted successfully), the module turns into the normal
operation, see LEDs in Table 3.
LEDs
2 E1/T1
Ports
2 C37.94
Ports
Handle
Fastening screw
