8. For the first start-up use the help of the ”setup assistent”.
This menu is entered by calling up the sub-menu ”factory setting” under ”setup”.
After the IRD 8500/.. was reset to the factory settings you are queried whether you
want to use the help of the setup assistent or not.
If your answer is ”Yes”, the following parameters must be entered:
l
MPEG input (SAT, SPI, TSI)
l
Sat input frequency (1st SAT-IF level)
l
Input symbol rate (4 ... 45 MSymb/s)
l
TS identifier (selection of the transport stream)
l
Select service (selection of the program)
l
Select language (selection of sound2)
With ”finished” you return to the main menu. The IRD 8500/.. is now ready for ope-
ration.
9. Check the LED´s on the front-panel.
l
LED ”
f ”
does not light up
l
LED ”OUT” lights up
10. Check the operating parameters of the IRD 8500/.. in the menus
”Sat receiver”, ”MPEG processing”, ”Conditional access”, ”Video processing” and
”Audio processing”.
11. For optimizing the IRD 8500/.. adjust the settings of all other parameters (e.g. ”Au-
dio level”) in the menus.
12. Set the desired warning- and alarm thresholds for the displayed values.
Putting into operation
IRD 8500/..
2 - 14
Intergrated Receiver Decoder
