Bunsen Jet HSI Radiant Brooder
2
2.2. Warnings
Read and understand all the following precautions before installing or operating this unit.
1.
Installation must comply with all local, state and national codes. In the absence of local
codes, in accordance with CAN1-B149.1 or .2 Installation Codes (Canada).
2.
Follow safety, maintenance, and test firing instructions packaged with Brooder.
3.
Refer to model specifications label for gas type (LP/Propane or Natural Gas).
4.
Check all connections for gas leaks.
5.
Gas supply and regulator must be installed outside building.
6.
The gas hose and all electrical wiring should be protected from traffic, building materials, and
any contact with hot surfaces both during use and while in storage.
7.
Do not move or handle brooder while hot, burning or connected to power supply.
8.
Disconnect power and turn off gas supply before servicing. (Brooder may start at any time!)
9.
Brooder surfaces may be hot. Do not permit feathers, hay, straw, dust or other combustible
materials to accumulate on brooder. A fire may result.
10.
Brooder is not recommended for heating human living quarters.
11.
Inadequate gas volume and(or) pressure will directly influence the combustion efficiency of
the brooder. Adequate gas volume and(or) pressure is the responsibility of the installer.
12.
Adequate ventilation must be provided.
13.
Combustion and ventilation air must not be obstructed.
14.
Position brooder properly before use. Brooder must be level and in accordance with minimum
clearances.
15.
Keep temperature of fuel containers below 100°F. Containers must be installed outside
building.
16.
Brooder must not be operated for one hour following wash-down.
3. Limited Warranty
All products are warranted to be free from defects in material and workmanship if installed and
used in strict accordance with the installation instructions. Liability is limited to the sale price of
any products proved to be defective or, at manufacturers option, to the replacement of such
products upon their return. No products are to be returned to the manufacturer, until there is an
inspection and a return goods authorization (RGA) number is issued.
All complaints should be directed first to the authorized distributor who sold the product. If
satisfaction is not obtained or the name of the distributor is not known, write the manufacturer that
appears below, directed to the attention of Customer Service Manager.
This limited warranty is expressly in lieu of any and all representations and warranties expressed or
implied, including any implied warranty of merchantability or fitness for a particular purpose. The
remedy set forth in this limited warranty shall be the exclusive remedy available to any person. No
person has authority to bind the manufacturer to any representation or warranty other than this
limited warranty. The manufacturer shall not be liable for any consequential damages resulting
from the use of our products or caused by any defect, failure or malfunction of our products.
(Some areas do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you.)
This warranty gives you specific legal rights and you may also have other rights which vary from
area to area.
Warrantor:
Hired-Hand, Inc.
1733 Co. Rd. 68
PO Box 99
Bremen, AL 35033
