Hioki 9332, Инструкция по эксплуатации

Страница: 31 / 44

27
_____________________________________________________________________________________________
Chapter 4 Using WAVE COMMUNICATOR
______________________________________________________________________________________________
Tel 3 This is the number to dial when a trigger occurs (the
telephone number of the computer on which WAVE
COMMUNICATOR is installed).
AT command 3 The modem initialization string for making a call. Enter if
required.
Notify Select Trigger or Measurement End .
Trigger : Notify when a trigger occurs.
Measurement End : Notify when waveform capture is
completed. Transfer the waveform data
at the same time.
Making the MEMORY HiCORDER Trigger Notification Settings
To use the trigger notification function on a connected MEMORY
HiCORDER, you must first make the
Notify
settings on the MEMORY
HiCORDER. For details of how to do this on the MEMORY HiCORDER
itself, refer to the Operation Manual. This section describes how to make the
settings using the communications function.
1. In the Settings Editor, create the setting file. For more details, see Chapter
6, "Creating and Modifying Setting Files."
In the Fax/Modem tab, make the following settings.
In the
Trigger
tab, if you set
Trigger mode
to REPEAT or AUTO, then
measurement resumes after sending trigger notification.
2. Send the new setting file, using the procedure in Section 4.7, "Sending
Setting Files."
If you check the Start measurement at end of communications box, after
sending the setting file, the MEMORY HiCORDER starts waveform
capture.
3. This completes the settings. When the trigger or measurement end occurs
on the MEMORY HiCORDER, it will make the telephone call.