Hino S5-LJ05E04A, Руководство по ремонту

Страница: 33 / 647

GENERAL INTRODUCTION 1–29
HANDLING OF LIQUID GASKET
EN01F01ZZZ000102003006
LIQUID GASKET
1. PROCEDURES FOR APPLYING LIQUID GASKET AND ASSEMBLING PARTS
(1) Thoroughly remove old liquid gasket remaining on individual parts and mating parts. Use clean cloth to remove oil,
moisture, dirt or other contaminants.
Make sure to overlap the start and end points of liquid gasket.
(2) Use care to avoid misalignment with a mating part when assembling a gasket-applied part. If misalignment is found,
reapply liquid gasket.
(3) Install parts within 20 minutes after applying liquid gasket.
If 20 minutes or longer time has elapsed, remove and reapply liquid gasket.
(4) Wait at least 15 minutes after assembling parts and then start the engine.
2. REMOVAL OF PARTS
(1) When removing individual parts, alternately winkle two or more portions in a gap or a collar of a flange. Avoid one-
point winkling. When removing a gasket, use care to avoid entry of gasket fragments into the engine.
3. OTHERS
(1) If liquid gasket is contained in a tube, use a supplied squeezer. If liquid gasket is contained in a cartridge, use a appli-
cator gun.
If liquid gasket is contained in a tube, the nozzle tip can be cut off to the desired application width.
1: Cut off the first block will form a application width of approximately 2 mm {0.079 in.}.
2: Cut off the second block will form a application width of approximately 5 mm {0.197 in.}.
1
SHTS01ZZZ0000042
SPRAY GUN
CARTRIDGE
WINDING TOOL
TUBE
SHTS01ZZZ0000043
2 1
NOZZLE OF THE TUBE