HANGING THE FAN
1
2
3
4
5
06
|
hinkley.com
Fig. 1
Fig. 2
Downrod
Cross pin
Hanger
ball
Set screw
Downrod
Hook-up
(5) Wires
Mounting Collar
Downrod Pin
Security Screws
Cotter Pin
Top of
Fan Body
Remove ball from downrod by loosening set screw in the side of the
ball. Slide ball down and remove ball pin; remove ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing with the
mounting collar (where the wires come out) facing upward.
Loosen the two security set screws and remove the downrod pin
and retaining clip from the coupling on top of the motor assembly.
(Fig. 2)
Carefully feed the electrical lead wires and safety cable from the fan
through the downrod. Thread downrod into coupler until holes
align. Insert downrod pin through holes in mounting collar and
downrod; clip cotter pin through small hole in end of downrod pin
to hold downrod in place.
Tighten security set screws against downrod using a large flat blade
screwdriver to ensure a tight fit against downrod. Tighten nuts
against mounting collar.
Содержание SCULPT 80
Страница 1: ...CEILING FAN INSTRUCTION MANUAL DC DC MOTOR LED DAMP INDOOR OUTDOOR LED FAN 80 SCULPT ...
Страница 20: ...GLOBAL HEADQUARTERS 33000 Pin Oak Parkway Avon Lake Ohio 44012 T 440 653 5500 F 440 653 5555 hinkley com ...
Страница 40: ...GLOBAL HEADQUARTERS 33000 Pin Oak Parkway Avon Lake Ohio 44012 T 440 653 5500 F 440 653 5555 hinkley com ...
Страница 60: ...GLOBAL HEADQUARTERS 33000 Pin Oak Parkway Avon Lake Ohio 44012 T 440 653 5500 F 440 653 5555 hinkley com ...