Hinkley 930008, Инструкция по эксплуатации, Страница: 3 / 12

INSTALLING THE LIGHT KIT
©2019 Hinkley Lighting, Inc.
|
hinkley.com
|
03
Fig. 1
Pull Chain
Connector (plug)
with Side Buckle
Keyhole Slot (x3)
Connector (receptacle)
Light Kit
Assembly
Thumbscrews
Glass
Shade
Bulb
Switch Housing Hub
(bottom of motor)
Fig. 2
Light Kit
Nut
Lock Washer
Center
Plug
Switch
Housing
1
2
3
4
5
7
8
6
Remove and discard the center plug from the switch
housing. Attach the light kit to the switch housing by feeding
the light fixture wires (black and white) through the hole in
the center of the switch housing, then screw the light fixture
stem onto the switch housing. (Fig. 1)
Thread the nut & lock washer onto the light fixture stem
inside the switch housing making sure the light fixture is
secure, preventing movement after installation. (Fig. 1)
Locate the white and blue wires inside the switch housing
labeled FOR LIGHT.
Attach the wires from the light kit to the wires inside the
switch housing by pushing the polarized connections
together. (Fig. 1)
- White wire to White wire
- Black wire to Black (Blue) wire
Raise and hold the light kit assembly close to the switch
housing hub of the ceiling fan. Push the square wire
connectors together. (Fig. 2)
NOTE:
The square connectors are color coded. Match the
color coded sides of each plug and push. They will attach
ONLY when matched correctly.
Carefully push all wires back into the switch housing, then
install the light kit assembly onto the switch housing hub
with 3 screws provided. Be sure to tighten all screws. (Fig. 2)
Install one 9 Watt LED bulb (included).
Mount the glass shade to the light sockets by unscrewing
partway the three light holder thumbscrews on glass holder.
Insert the glass shade, then gently tighten the thumbscrews
by hand evenly to the thumb shade. Do not overtighten.
WARNING:
Be sure electricity is turned off at the main power box
before wiring.